Archive for April, 2010

What is Green plumbing? Well, Green plumbing when applied to residential plumbing layouts, would mean plumbing that reduces your energy and or water wastage; an efficient plumbing system.

There are a variety of products out there that can save you water, but some are counter productive and some are a pain in the you-know-what. Others are certainly worthwhile and can even save you money.

The biggest factor involved in water and energy wastage is human behavior. It’s our behaviors that waste the most energy and the most water. We all does it… leave lights on, leave water running when not necessary, linger in the shower… Going Green seems to often lead to less convenience. But humans are after exactly that… convenience. That’s why microwave ovens, took off. Dishwashers, washing machines, trash compactors, automatic sprinkler systems, it’s all about convenience.

Some water conservation products address these behaviors. Low flow fixtures reduce the rate at which water flows from a fixture, so we use less water when we leave it running. This can be an inconvenience though, when you have to stand there and wait longer to fill up that pitcher or sink. Low flow toilets that don’t always work with one flush.

There are numerous “gray water” systems that reclaim waste water like from your washing machine to use in flushing toilets or watering the lawn.

It’s not hard to find water saving appliances such as dishwashers and washing machines. Probably all of them now at least have water conservation cycles or modes. I recently was talking to a guy who had just bought a new Bosch water conserving dishwasher. He was having a problem because the dishwasher didn’t draw a high enough flow of water to turn on the water heater. To get clean dishes he has to run hot water in the sink while the dishwasher fills. So much for water conservation.

There are some water conservation products which do offer both convenience and save water. They are known as hot water demand systems. They get you your hot water to you faster and you don’t run any water down the drain. The pumps are very efficient consuming less than $2.00 per year in electricity to operate. Not only are you saving water and energy with a demand system, but you are also reducing your carbon foot print.

Every gallon of water that you do not dump down the drain is one gallon less sewage that has to be treated and pumped etc which in turn uses less energy and thus results in reduced Green house gas being released into the atmosphere.

Don’t confuse hot water demand systems with those “luke warm circulating systems” on the market like the Laing Autocirc1, the Grundfos Comfort System, and the Watts Premier. These systems circulate warm water through the hot water piping and the cold water piping, but in doing so consume a lot of energy making your water heater work harder and costing you money. You also end up with warm water in your cold water lines and you must purge those lines of the lukewarm water to get cold water from the faucet.

Tankless water heaters typically take longer to get hot water to your fixtures wasting more water than hot water systems that use tank type water heaters. Demand hot water systems do work with tankless water heaters as long as you get one powerful enough, some just don’t have enough power to generate enough flow to turn on a tankless water heater.

So go Green and install a hot water demand system. It’s a very earth friendly thing to do. You will feel good about what you are doing for the planet and you get the added convenience of fast hot water!

Many households

single-family houses and apartment buildings in the past, full-time hot water circulation pumps installed and systems built. This certainly saves a lot of water, but also an enormous waste of energy. We are hot water recirculation Recirculation systems were generally used in larger homes, that is to send 3,000 square meters and above. long legs means long waiting times, and if you have a big house that you do not want to wait forever on the hot water could afford to go. Full-time closed-circuit installations spread slowly the hot water through the pipes hot water to the water in the pipes to keep warm for immediate use. Put on a crane, and within one or two seconds you have hot water. It is a great convenience, but it is a punishment. energy wasting

your hot water heat exchanger is a huge allows your boiler longer, more frequent fires. Not only is this waste an enormous amount of energy, but it increases the wear and tear on your boiler. Even if you isolate strong pipes and turn the pump on a timer RECIRC, have you always spend lots of money for this waste of energy. There is no help for your carbon footprint either. Not only variousand more energy. tankless water heater RECIRC pumps are normally not used in conjunction with tankless water heaters, because they do not usually enough to pump gallons per minute to the tankless water heater set. With a conventional residential hot water circulation system, the warranty on most tankless water heaters will be void. hot water demand system A demand hot water system on the other hand, continue to save thousands of gallons of water per year, and it will not waste any energy. Demand pump systems are used typically about $ 1.00 a year in electricity to the pump. This is because the pump only runs for a few seconds and only if you really want hot water. With a demand system, simply press a button if you want hot water, and that starts the pump. The pump sends water to be affixed to a faster rate than when the tap was running normally. If the hot water reaches the device, the pump is turned off, and when the crane you have hot water instantly. No water carried into the drains. The installation is simple. Simply remove the old pump and replace it with a demand pump. Buttons can be hard to use the points of use or wireless switches wired weis a good feeling every time you know your hot water that you do your part to reduce global warming! There are several manufacturers of hot water demand systems and they range in price from less than $ 200 to almost $ 1,000. Most demand for hot water systems will also work with tankless water heaters. Go Green with a demand for hot water, the existing system.

Related Blogs

Tankless Water Heater Gas

, because it requires so much energy for rapid heating of the water, gas burner in the tank tankless less More … Hot water boilers are larger than the tank type heater. Thus, the ventilation, it is usually with a larger diameter than conventional boilers. You should be a very high efficiency units with breakdown of the “stainless steel. To ensure greater efficiency, it absorbs more heat from stale air and then cold and acidic gases on the walls for ventilation to condense. Therefore they must be made of stainless steel. tankless water heater are two different types, models inside and out. models are installed outdoors on a wall outside the bathroom or built a building from outside of the emergency lighting is required. typically 41 or 49.6 gallon of water, gas consists of a cylindrical tank top with a hemispherical combustion chamber on the bottom of the pipe (chimney), which from the combustion chamber through the center of the basin and at the top. Some models require a gas supply to the electronic circuit that regulates the temperature and the lack of energy, so that working models, not more. A ce. In general, a wide range of electric water heaters, a separate power supply for the operation and switches the switch correctly. In some areas may be higher failed the incoming cold water below 40 degrees Celsius, and in other areas in the 50s or. In general, the elements above and below each with its own thermostat and are wired so that a single element comes at a time. Normally, the thermostat is higher in the first place, when the roof is hot, leads the new thermostat higher power, the thermostat and the lower element. This provided a big difference in the amount of hot water, the device can. And the temperature of cold water can change significantly from summer to winter. If the radiator is good, then you get a reading of less than 50 ohms. When the heating element is burned, the counter will read infinity or open circuit. The meter should give you a reading at idle between the terminals and the metal housing of the element water heaters. Tankless water heaters have a minimum flow required to work. However, if the lowering of the temperature and thus reduce the flow of hot water boiler on the market

Related Blogs

How much does a water heater cost?

Has anyone had a water heater replaced recently? How much did it cost and how much was labor? I think ours has a slow leak and just trying to get an idea what we might be looking at before we start making calls. Thanks!
It is a gas water heater for a two bathroom house. Not sure where it is leaking from. I just placed a bucket under the relief valve hose/pipe to see if it is coming from there, but I can also see some rust on the bottom so am thinking I might need to have it looked at and possibly replaced.


Related Blogs

Can I use teflon tape when replacing a water heater relief valve, or do I need to use pipe dope.


Related Blogs

 Page 10 of 10  « First  ... « 6  7  8  9  10 

Powered by Yahoo! Answers